Dress
up the plain pivot point nut with one of these beautiful CruiserFX chrome covers.
Made from super-tough
ABS, the glasslike surface of this chrome plated cover is
impressive.
Installation is
super easy! No special
tools are required. (Should take you about a minute.)
Just slip it over the fork nut, and tighten the set screw with the included
wrench
This is how your
bike left the factory.
This is what CruiserFX
is proud to offer.
available in Skull or Maltese Cross design
Chrome Plated ABS Axle Covers
The
high-quality finish of these super-tough ABS covers will not disappoint you.
Measurements: 1 3/8" diameter by 1" long.
Installation is
super easy! No special
tools are required. (Should take you about a minute.)
Just slip it over the hex nut and tighten the set screw with the included
wrench.
(Covers use stainless steel
self-locking set screws to securely hold them to the front axle.)
If your specific model
and year was not mentioned above, please take special note of the following: It is
actually quite a challenge to list all the Harley models these covers will fit.
There have been many variations made from year to year of various components.
Therefore, we offer the following photos and dimensions so you can more easily
determine whether or not these covers will fit.
Using a
tape measure or ruler, measure the width of the hex nut (from flat to
flat). If the
nut measures 1" across and if it looks like the above picture, you should be fine.
Note: Although the same size
nut is used on both sides, the left side is not really accessible, nor is it
very visible.
Important FYI to prospective
buyers:
What if you purchase this
product and after seeing it in person you don't like it?
