Cover
up the hideous rear axle nuts with a pair of these beautiful CruiserFX chrome
covers.
Made from super-tough
ABS, the glasslike surface of this chrome plated cover is
impressive.
Installation is
super easy! No special
tools are required. (Should take you about a minute.)
Just slip it over the fork nut, and tighten the set screw with the included
wrench
As you are no
doubt very aware of, this is what
the factory gave you.
This is what CruiserFX
is proud to offer.
Skull design -
Chrome ABS
Maltese Cross design - Chrome ABS
Chrome Plated ABS Axle Covers
These covers are made from
the super-tough material
ABS,
which
has an extremely
high-quality finish that will not disappoint you.
Measurements: 1 3/8" diameter by 1
1/4" long.
Installation is
super easy! No special
tools are required. (Should take you about a minute.)
Just slip it over the hex nut and tighten the set screw with the included
wrench.
(Covers use stainless steel
self-locking set screws to securely hold them to the front axle.)
If your specific model
and year was not mentioned above, please take special note of the following: It is
actually quite a challenge to list all the Harley models these covers will fit.
There have been many variations made from year to year of various components.
Therefore, we offer the following photos and dimensions so you can more easily
determine whether or not these covers will fit.
Using a
tape measure or ruler, measure the width of the rear axle hex nut (from flat to
flat). If the
nut measures a little less than 1 1/8" across (1 3/32" or 28mm to be more
precise) and if both sides look like the above pictures, you should be fine.
Important FYI to prospective
buyers:
What if you purchase this
product and after seeing it in person you don't like it?
'Click'
here to
